U.S. Department of Justice
Civil Rights Division
Disability Rights Section

Department of Justice seal


 

Solutions for Five Common ADA
Access Problems at Polling Places


Voting is one of our nation's most fundamental rights and a hallmark of our democracy. Voting in-person on Election Day is the way most Americans cast their ballot and vote, but for far too long, many voters with disabilities who use wheelchairs or other mobility devices have had difficulties getting inside polling places to vote because of architectural barriers. Title II of the Americans with Disabilities Act (ADA) requires public entities to ensure that people with disabilities can access and use their voting facilities.

This publication provides a brief discussion of physical barriers to access in five commonly found areas at polling places: parking, sidewalks and walkways, building entrances, interior hallways, and the voting area itself. It is intended to assist election officials to meet their ADA obligation to provide polling places that are accessible to and usable by individuals with disabilities. To provide access to the polling place, a route into and through the polling place must be accessible to voters with disabilities. This accessible route should connect each area, from parking to the voting area and back again and should be the same route all voters take. If this is not possible and alternate routes must be used to provide access for voters with disabilities, temporary signs should direct voters to and along these alternate accessible routes.

While locating polling places in accessible facilities makes ADA compliance more likely, there may be times when that is not possible and the use of temporary measures to provide access will be necessary.

overhead view of the front of a polling place

Entrance to a polling place with the accessible route
shown from parking and drop off areas into the polling place

Temporary Measures

While permanently removing architectural barriers is preferable, this document provides some low-cost, temporary solutions that can provide temporary access for people with disabilities on Election Day.

picture of person using a wheelchair entering polling place

A person using a wheelchair enters a polling place

Temporary measures may not be suitable for every polling place that has physical barriers that block access. For example, if the only entrance door at a polling place is 29 inches wide, then propping the door open or providing a doorbell for a poll worker to open the door will still not allow a person using a wheelchair or a walker to pass through the door. If another accessible entrance is not available, the door must either be permanently modified or the polling place must be relocated to an accessible facility.

Common Problems

Parking

Problem

Many polling places provide parking for voters but the provision of accessible parking is often overlooked. Parking areas may lack accessible parking spaces with adequate access aisles and signs, or may be on a sloped surface. Also, because other entrances – not the main entrance to the building – are commonly used as entry points to the polling place, especially at large facilities such as schools, permanent accessible parking may not be close to the entrance to the voting area.

All of these barriers can prevent voters with disabilities from reaching the polling place.

image showing a person using a scooter getting out of van at a temporary van parking space marked with traffic cones to create a  parking space and access aisle

A van parked in a temporary accessible parking space
marked with traffic cones to create the access aisle
and accessible route and a temporary ramp provides access to the sidewalk

ADA Requirements

Parking provided at the polling place must meet specific minimum width requirements for spaces and access aisles so voters with mobility disabilities can get out of their car or van. Generally, the access aisle must be of at least 60 inches wide for cars and 96 inches wide for vans. Van spaces can also have an access aisle at least 60 inches if the width of the van parking space is at least 132 inches. A sign, with the International Symbol of Accessibility, must mark each accessible parking space. Van-accessible spaces must be designated as such on the sign at these spaces. If only one accessible space is provided, it must be a van-accessible space. Accessible parking spaces must be in a level area with no steep slopes and on the shortest accessible route from parking to the accessible entrance to the polling place.

Temporary Solutions

Temporary parking must be located on the most level area available and as close to the accessible entrance as possible. Traffic cones and portable signs can be used to create accessible parking spaces and access aisles.

photo of a temporary sign providing direction

Temporary sign providing direction to the area for van-accessible parking

Sidewalks and Walkways

Problem

If sidewalks and walkways are in disrepair, it can be difficult, and sometimes impossible, for a voter using a wheelchair or other mobility device to safely navigate to the polling place. Often, sidewalks and walkways are uneven, cracked, or contain potholes, gravel, dirt, or grass. Some sidewalks do not include curb ramps or, if they do, the ramped section is too narrow or steep.

Photo of a sidewalk with broken pavement, raised sections, and patches

A sidewalk with raised and broken sections is a barrier to access

ADA Requirements

Sidewalk or walkway surfaces must be at least 36 inches wide, without abrupt level changes (no level change greater than ½ inch), and the surface must be stable, firm, and slip resistant. Curb ramps should not be too steep (no steeper than 1:12).

Temporary Solutions

Temporary plates (no more than ½ inch thick) can be used to cover holes or cracks and provide a more level walkway. Ramps at least 36 inches wide, with a slope no more than 1:12, may be used to provide temporary access over curbs or onto sidewalks.

Entrances

Problem

The entrance area must be level (no level change greater than ½ inch) and should not slope steeply in any one direction. All door openings must provide a minimum width of 32 inches and there must also be enough room for a person using a wheelchair to maneuver to open the door, including 18 inches of clear space beyond the latch side of the door. Additionally, the door hardware must not require tight grasping, pinching, or twisting, and the height of the door threshold must not be greater than ½ inch.

ADA Requirements

The entrance area must be level (no level change greater than ½ inch) and should not slope steeply in any one direction. All door openings must provide a minimum width of 32 inches and there must also be enough room for a person using a wheelchair to maneuver to open the door, including 18 inches of clear space beyond the latch side of the door. Additionally, the door hardware must not require tight grasping, pinching, or twisting, and the height of the door threshold must not be greater than ½ inch.

Temporary Solutions

The use of temporary ramps can provide access over steps or high thresholds. If the area in front of the door is not level or does not provide adequate maneuvering space, then the door may be propped open to allow the person using a wheelchair to enter the polling place. If one door of a double-leaf door is not wide enough, propping open the second door may provide enough clearance. In some circumstances, temporary levers or other adapters that do not require tight grasping, pinching, or twisting, may be installed over existing door hardware to provide independent access. Alternatively, a temporary doorbell or buzzer system may be used to alert a poll worker to open the door or doors for the voter.

image showing a door to a polling place being held open by staff

Entry doors to the polling place can be
propped open or opened by staff to provide access


image showing a temporary ramp installed at the entrance to a polling place

A temporary ramp with handrails and edge
protection provides access over steps

Hallways

Problem

man who is blind walking with a white cane runs into a drinking fountain that is a protruding object

In many polling places, particularly those in large facilities such as schools and apartment buildings, hallways contain drinking fountains, coat racks, fire extinguishers, and other protruding objects. These objects may pose hazards to voters with vision disabilities, who may bump into them if they are not detectable by a sweep of a cane.

ADA Requirements

Wall-mounted objects located between 27 inches and 80 inches above the floor may not protrude or stick out from the wall more than 4 inches.

Temporary Solutions

Place traffic cones or other cane-detectable barriers, such as planters or portable railings, at or under protruding objects. Cane-detectable barriers can also be placed to re-direct voters with vision disabilities around or away from the protruding object. An alternate pedestrian route that does not include the protruding object, if available, may be appropriate.

image showing several wall-mounted objects mounted so they are not protruding objects and a man using a white cane using the base of the wall as a shoreline

A voter who is blind walks along a corridor with wall-mounted objects
that are not protruding objects because they do not protrude
more than 4 inches from the wall,
are mounted above 80 inches or are recessed into an alcove

Voting Areas

Problem

Voting often occurs in a small room or area within a building, with little space at the check-in tables and voting machines, making it difficult for voters with mobility disabilities to move through the voting area and cast their ballots. In winter months or during the rainy season, election officials may use cardboard, plastic floor coverings, tarps, or mats to cover the floor. These coverings can make it difficult to navigate and can easily become trip hazards for voters with disabilities and others.

ADA Requirements

There must be a minimum 36 inch wide route in and through the voting area. There also must be enough clear floor space in at least one voting station or booth to allow a voter using a wheelchair or other mobility device to approach, maneuver, and leave the voting station. Floor surfaces must be stable, firm, and slip resistant.

Temporary Solutions

Arrange check-in tables and voting stations to provide an accessible path for the voter to go from the check-in table to the voting station and out again. At least one voting station should provide at least 30 x 48 inches of clear floor space to allow a voter using a wheelchair or other mobility device to maneuver. All floor coverings, such as cardboard or plastic sheets, should be removed or firmly affixed to the floor to provide a stable and slip-resistant floor.

image showing a woman using a power wheelchair pulling up to an accessible voting machine

An accessible voting station with clear floor space


view of a polling place showing accessible route and turning space.

Overhead view of the polling place showing
the accessible route and maneuvering spaces
for voters who use mobility devices


Voting Access: Where to Start

To provide temporary access to voters with disabilities, election officials should always keep in mind the accessible route into and through the polling place. Understanding how all voters arrive at the polls, park or drop people off, move through the facility and the voting area, and back out again will help identify physical barriers that will need to be remediated. Using the tools discussed in this document can provide temporary access and will ensure that voters with disabilities can fully participate in the election process.

Voting Access: Some Useful Resources

This document provides guidance on providing temporary access to polling places. Election officials should note that the ADA requires jurisdictions to select polling sites that are accessible or can be made accessible for elections. The ADA title II regulation and the ADA Standards for Accessible Design set out what makes a facility accessible and should be used to determine the level of accessibility at each facility being used or considered for use as a polling place. Election officials should consult the Justice Department’s ADA Checklist for Polling Places for more detailed guidance on how to assess whether a polling place is fully accessible to voters with disabilities or if barriers can be removed.

The Checklist, title II regulation, and the ADA Standards are available at
archive.ada.gov.

In addition, election officials should consult the Department’s 7-page publication on the rights of voters with disabilities, The Americans with Disabilities Act and Other Federal Laws Protecting the Rights of Voters with Disabilities, also available at archive.ada.gov.

For More Information

For information about the ADA, please visit our website or call our toll-free number.

ADA Information Line
800-514-0301 (Voice) and 833-610-1264 (TTY)
24 hours a day to order publications by mail.
Monday - Wednesday, F
9:30 a.m. – 5:30 p.m.,
Th 12:30 p.m. – 5:30 p.m. (Eastern Time) to speak with an ADA Specialist.  All calls are confidential.

ADA Website
archive.ada.gov

To receive e-mail notifications when new ADA information is available, visit the ADA Website’s home page and click the link near the lower right corner of the page.

The Americans with Disabilities Act authorizes the Department of Justice (the Department) to provide technical assistance to individuals and entities that have rights or responsibilities under the Act. This document provides informal guidance to assist you in understanding the ADA and the Department's regulations.

This guidance document is not intended to be a final agency action, has no legally binding effect, and may be rescinded or modified in the Department's complete discretion, in accordance with applicable laws. The Department's guidance documents, including this guidance, do not establish legally enforceable responsibilities beyond what is required by the terms of the applicable statutes, regulations, or binding judicial precedent.

October 9, 2014